Tafee Bowle 2 LED Activity After Use (What It Means & How to Fix It)Updated 3 hours ago
If you notice your Tafee Bowle 2 LEDs lighting up after a session, you’re not alone. This is a known and harmless behavior confirmed by the manufacturer.
Let’s break down what’s happening and what you can do 👇
💡 Why Do the LEDs Turn On After Use?
After a session, your device may show brief LED activity while in standby.
This is caused by:
- A firmware-driven indicator
- Internal battery cell evaluation after use
- The device stabilizing after a high discharge session
👉 This is completely normal and does not indicate a problem.
🔍 Does This Affect Performance or Safety?
No 👍
- ✔️ No impact on performance
- ✔️ No impact on safety
- ✔️ No impact on device functionality
Your Bowle 2 is working exactly as intended.
🔋 Does This Drain the Battery?
Not in any meaningful way.
- The battery is only actively used when the heater is engaged
- The LEDs use minimal power
👉 You won’t notice any significant change in battery life.
⏳ Will the LED Activity Stop?
In most cases, yes.
- The LED behavior typically fades after a few full charge cycles
- As the firmware adapts to your battery’s baseline, the activity becomes less noticeable over time
🔕 How to Turn the LED Off Manually
If you prefer to stop the lights right away:
- Press the small Power Level Select button while the device is in standby
🔄 Optional: Reset Your Device
If you’d like to speed up the process, you can perform a reset:
Follow these steps carefully:
- Make sure the Puck Base Unit is powered on
- Ensure it is in standby (not in use)
- Confirm it is not connected to the charger
- Rapidly press both:
- Fire button
- Power Level Select button
at least five times
- The LEDs should flash blue briefly and then shut down
Confirm the reset:
- Press the Fire button three times
- The device should remain off
👉 If it still shows power, repeat the steps until it fully shuts down.
Before using again:
- 🔌 Connect it to the supplied charger
When Should You Be Concerned?
You may want to reach out if:
- LED activity continues after several weeks of normal use
- You notice anything unusual beyond the behavior described above
Need Help? We’re Here 💚
If you have questions or want help troubleshooting:
- 📧 Email us at [email protected]
We can also check if a manufacturer service update is available for your device.
Quick Tips Recap
- ✔️ LED activity after use is normal and harmless
- ✔️ Caused by battery stabilization + firmware behavior
- ✔️ Does not affect performance or battery life
- ✔️ Usually stops after a few charge cycles
- 🔕 Can be turned off manually or reset if needed